Skip to Content
Help Center
B-hyve Smart Indoor/Outdoor Irrigation ControllerMy programmed cycles don’t run, but my manual cycles do

B-hyve Smart Indoor/Outdoor Irrigation Controller

My programmed cycles don’t run, but my manual cycles do

Try this solution

Follow the steps below

The timer will run manually, but will not run automatically. If your timer is not watering your Programs, but it is watering your manual watering cycles, you likely have your rain sensor terminal active.

To turn off your rain sensor terminals:

  1. Make sure your timer is in the “Auto” position.

  2. Hold down the “Rain Delay” button for 5 seconds.

  3. Your timer display should show “SENS OFF”.

  4. Your sensor terminal is now off and your system should run automatically.

Repeat these steps to turn the sensor terminals back on if you have a rain sensor attached to the timer.

Note: If your timer does not have a rain sensor attached to the sensor terminals and your rain sensor terminals are active, your timer will not run programmed water cycles.

Need more help?

Ask a different questionB-hyve Smart Indoor/Outdoor Irrigation Controller
Select a different product
On this page