B-hyve Smart Hose Watering Timer

• Adjust cycle period to the desired number of minutes. Remove the thermostat from the wall plate.

• While holding down the reset button, press down the set button until the offset indicator appears. Release reset button.

• Immediately press the set button twice. (Offset setting will not be lost).

• Use up & down arrows to toggle between 0, 12, 15, 20, 30 and 60 for heat pumps – 0, 6, 8, 10, 12, 15, 20, 30, and 60 for furnace.

• Press the set button again to select desired cycle period. Replace thermostat to wall mount.

• Slide mode switch to heat or cool & wait 10 seconds.

Set temperature is 10° above original set temp in cooling mode, or 10° below original set temp in heating mode

• Check if low battery indicator is on

• Replace batteries